توان پایش ماد

HESEX


Conveyor Belt Misalignment Switch - HESEX
Hesex_1
Application:

Kiepe Belt Misalignment Switches are used in conveyor installations for monitoring the true running of conveyor belts.
The switches, when mounted at the running edges of a conveyor belt, will be operated if the belt deviates from it’s designed running line by more than a permissable distance.
The Kiepe Belt Misalignment Switches HESEX are approved for use in areas with combustible dusts acc. to EN 50281-1-1, part 1-1:
Electrical apparatus protected by enclosures.
The switches are marked with ATEX II 2D IP 65 T 85 °C and can be used in zones 21 and 22, equipment group II, categories 2 and 3.
The Belt Misalignment Switch HESEX is used for conveyor installations subjected to especially severe operating conditions.
The actuating roller of stainless steel is carried in stainless steel ball bearings for improved handling of laterial forces and jerks.
The large roller diameter of 48 mm permits the use of this device where fast belt speeds prevail. All external parts are either of stainless steel or have been specially plated.
The trip points are to be adjusted within 5 and 15° resp. 15 and 35° by means of movable actuating cams.

Technical Data:

Hesex_2


Accessories:

Hesex_3

Use only cable glands and plugs recommended by the manufacturer and supplied with the switch. These cable glands and plugs are designed acc.
to ATEX EU design sample test certifi cation.
The use of other cable glands and plugs may lead to a void device type approval.

Dimensions:

Hesex_4

Contact Arrangements:

Hesex_5

Certificates:

Hesex_7

Hesex_6


Application:

Kiepe Belt Misalignment Switches are used in conveyor installations for monitoring the true running of conveyor belts. The switches, when mounted at the running edges of a conveyor belt, will be operated if the belt deviates from it’s designed running line by more than a permissable distance.
The switches will then stop the conveyor drive, avoiding spillage of material or damage to the plant. The Belt Misalignment Switches can be optionally supplied with a pre-alarm position for an alert signal at slight deviation and a fi nal cut-out and lock. All switches are maintenance free.

Product Description:

The switch enclosure consists of corrosion-resistant aluminium alloy. All external parts are either of stainless steel or have been especially plated. The actuating roller is of polyamide. All VGtypes ars fitted with snap acting switches. The actuating head is removable from the main switch body and may be re-fitted in any of four positions. This, together with re-positioning of the switch trip bar allows the actuating roller to operate in any of four directions giving greater mounting versatility. All this will insure extremely safe operation, permitting to use the switch for severe operation and in outdoor installations.
No maintenance will be required. For the Models VG…/5 and 6 the switching point has been set at the manufacturer’s plant to approx. 12° from vertical and can be continuously readjusted in the field. The Model VG…/6 switch will latch as the admissable amount of out-of-line running is exceeded. It is unlatched locally by resetting the actuating roller. The VG 133/6 switch is equipped with two snap acting switches. An alert signal will be brovided at approx. 12°, the final cut-out and latch will occur at 45°. For unlatching, the actuating roller is reset by hand.

Selection Table:

Hesex_8



Technical Data:

Hesex_9

Contact Information:

Terminal Markings corresponding to DIN EN 50013
Hesex_10